If you can't get to a neurologist, stretching/flossing exercises for ulnar nerves might be of assistance. And the neurologist would probably suggest you see a career rehab specialist, who subsequently would just suggest the same exercises.
Your username and password for these discussion forums are unique to the forums. Your forum login information is separate from your My Adventure Cycling login information, and your login info for the Cyclosource online store. You will need to create a separate login for each of these. However, to make things a bit easier, you can use the same email and password for all three accounts. Also, please note that your login information for the forums is not connected to your Adventure Cycling membership number. We apologize for any inconvenience caused.
We have blocked registrations from several countries because of the large quantities of spam that originate there. If the forum denies your legitimate registration, please ask our administrator for an exception. email@example.com will need your IP address, which you can find at many web sites, including http://whatismyipaddress.com.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I did about 20 years ago on my Bill Vetter touring frame. It had been professionally re-painted a couple of years before and looked brand new so I had no concerns about rust in the near future. A bubble of paint appeared on the top tube and this is what was below. I'm not certain, but I think the rust started on the surface perhaps caused by sweat dripping from above. It served me well though. One Trans Am and several long trips through the Rockies and France.
More importantly, grease your seatpost and put on full coverage fenders. No more water in frame.The OP didn't find that to be the case
I don't have much experience with other modern headlights but I currently use a Busch & Meuller IXON IQ .+1 on that. I love the B&M IXON IQ. The only light that I like better is a Supernova E3 Pro, which is really an apples and oranges comparison.
I like the Princeton Tec Eos too!
Andy Blance of Thorn bikes in the UK is dead against discs on blade forks, claiming they won't take the torque. Not the spokes or tyres, but the forks! He won't supply them except on tubular forks (very rigid and uncomfortable) or shocks.The materials engineering for disc forks is solid. The Kona Project 2 disc fork (Kona Sutra) is plenty cushy and comfortable. If these were so failure prone, you would hear a lot about it, rather than seeing Kona continue to produce the Sutra and the Project 2. Salsa, Surly, Trek (Portland), and so on... all these manufacturers have comfortable disc forks. This past weekend, I took my Salsa Fargo 2 on a 260 mile fully loaded trip over chip seal, dirt roads, and nasty pavement. Plenty of steep descents with hard braking.